Prepare Your Model
Follow the instructions outlined below to prepare you model for custom milling.
Follow the instructions outlined below to prepare you model for custom milling.
To provide you with custom products of the highest quality it is critically important that you have an understanding of needs for model and die preparation as well as an understanding of the limitations of our scanners.
Our scanners do not allow for scanning models on large articulators. In addition, modes with large stone bases that are normal when articulating cases on adjustable articulators are too tall to scan. As a result of these limitations, we ask that you provide your models to us using the following protocol.
All models that contain implant analogs should be poured with soft tissue. The soft tissue material should be removable for the cast. There is no need to make implant sections removable. Solid models poured in low expansion stone are ideal. However, if there is a mix of analogs and natural tooth preps in the same arch the prepared tooth (teeth) dies must be removable and trimmed.
Cases that are received by CAP that do not meet these standards will be corrected by our technical staff. In this event, normal model and die charges will be applied.